Install The Sensor(S) - Emerson Rosemount FCL-01 Reference Manual

Installation
October 2023
2. Adjust the sample flow until the water level is even with the central overflow tube
3. Confirm that sample is flowing through the flow cells.
1.5

Install the sensor(s)

Emerson provides the Rosemount FCL with the sensor cable pre-wired to the transmitter.
Procedure
1. Connect the chlorine sensor (499ACL-01-54-VP) to the cable labeled CL.
2. Connect the pH sensor (3900-VP-02-10) to the cable labeled pH.
3. Once the key has slid into the mating slot, tighten the connection by turning the
4. Screw the sensor(s) into the plastic fitting(s), which are held in the flow cell(s) by the
10
and excess water is flowing down the tube.
The terminal end of the sensor is keyed to ensure proper mating with the cable
receptacle.
knurled ring clockwise.
union nut.
Do not remove the protective cap on the sensor(s) until ready to put the sensor(s) in
service.
Reference Manual
00809-0200-3412
Emerson.com