Using ProLink III with the transmitter
March 2019
Figure B-1: Service port inside transmitter wiring compartment
3. Start ProLink III.
4. Choose Connect to Physical Device.
5. Set parameters as shown here.
Parameter
Protocol
PC Port
6. Click Connect.
Need help?
If an error message appears:
•
Ensure that you have specified the correct port on your PC.
Ensure the transmitter service port is enabled at Menu > Configuration > Security > Service Port
•
318
Setting
Service Port
The number assigned to the USB port on your PC
Micro Motion Model 5700 Transmitters with Configurable Outputs
Configuration and Use Manual
MMI-20025166