Emerson Micro Motion 5700 Configuration And Use Manual page 324

Using ProLink III with the transmitter
March 2019
Figure B-5: Connection over network
A. PC
B. Signal converter
C. 120-Ω, 1/2-watt resistors at both ends of the segment, if necessary
D. DCS or PLC
E. Transmitter, with wiring compartment and power supply compartment opened
Note
This figure shows a serial port connection. USB connections are also supported.
4. Start ProLink III.
5. Choose Connect to Physical Device.
6. Set parameters as shown here.
Parameter Setting
PC Port
The number assigned to the COM port or USB port on your PC
Address The HART address configured for this transmitter. The default is 0.
Parity Odd
The transmitter automatically detects all other communications settings.
7. Set Master as appropriate.
Option Description
Secondary Use this setting if a primary HART host such as a DCS is on the network.
Primary Use this setting if no other primary host is on the network. The Field Communicator is a
secondary host.
8. Click Connect.
324 Micro Motion Model 5700 Transmitters with Configurable Outputs
Configuration and Use Manual
MMI-20025166