Suzuki SY413 Service Manual page 2554

ALWAYS CARRY AIR BAG (INFLATOR) MODULE
WITH TRIM COVER (AIR BAG OPENING) AWAY
FROM BODY.
ALWAYS PLACE AIR BAG (INFLATOR) MODULE
ON WORKBENCH WITH TRIM COVER (AIR BAG
OPENING) UP, AWAY FROM LOOSE OBJECTS.
1. Slit on workbench
2. Workbench vise 3. Lower mounting bracket
20) Dispose of the deployed air bag (inflator) module through nor-
mal refuse channels after it has cooled for at least 30 minutes
and tightly seal the air bag (inflator) module in a strong vinyl
bag. (Refer to "DEPLOYED AIR BAG (INFLATOR) MODULES
DISPOSAL" in detail.)
21) Wash your hands with mild soap and water afterward.
NOTE:
The remaining steps are to be followed in the unlikely
event that the air bag (inflator) module did not deploy after
the following these procedures.
22) Ensure that the deployment harness has been disconnected
from the power source and that its two banana plugs have
been shorted together by fully seating one banana plug into
the other.
23) Disconnect the deployment harness from the air bag (inflator)
module.
WARNING:
D Always carry a live air bag (inflator) module with trim
cover away from you.
D When storing a live air bag (inflator) module or when
leaving a live air bag (inflator) module unattended on
a bench or other surface, always face the bag and trim
cover up and away from the surface. As the live pas-
senger air bag (inflator) module must be placed with
its bag (trim cover) facing up, place it on the work-
bench with a slit or use the workbench vise to hold it
securely at its lower mounting bracket.
D This is necessary so that a free space is provided to al-
low the air bag to expand in the unlikely event of acci-
dental deployment.
Failure to follow procedures may result in personal inju-
ry.
24) Temporarily store the air bag (inflator) module with its vinyl trim
cover facing up, away from the surface upon which it rests.
25) Contact your local distributor for further assistance.
AIR BAG SYSTEM 9J-85