Suzuki SY413 Service Manual page 2553

9J-84 AIR BAG SYSTEM
1. Connect one banana plug to positive terminal of power
source (12V vehicle battery) and then the other to
negative terminal to immediately deploy.
2. Short the two deployment harness leads.
14) Separate the two banana plugs on the deployment harness.
15) Connect the deployment harness to the power source (12V
vehicle battery) to immediately deploy the driver or passenger
air bag.
16) Disconnect the deployment harness from power source (12V
vehicle battery) and short the two deployment harness leads
together by fully seating one banana plug into the other.
17) In the unlikely event that the driver or passenger air bag (infla-
tor) module did not deploy after the following these proce-
dures, proceed immediately with Steps 22) through 24). If the
air bag (inflator) module did deploy, proceed with Steps 18)
through 21).
18) Put on a pair of shop gloves to protect your hands from pos-
sible irritation and heat when handling the deployed air bag (in-
flator) module.
NOTE:
As a precaution, gloves and safety glasses are recom-
mended to prevent any possible irritation of the skin or
eyes.
19) Disconnect the deployment harness from the air bag (inflator)
module as soon after deployment as possible. This will pre-
vent damage to the deployment harness due to possible con-
tact with the hot air bag (inflator) module canister. The
deployment harness are designed to be reused. They should,
however, be inspected for damage after each deployment and
replaced if necessary.