Suzuki SY413 Service Manual page 2557

9J-88 AIR BAG SYSTEM
1. Drop cloth blanket or similar item.
1. Stretch it to full length 10 m (33 ft).
2. Power source (12V vehicle battery)
3. Connect one banana plug to positive terminal of power
source (12V vehicle battery) and then the other to negative
terminal to immediately deploy.
4. Short harness leads after deployment.
5. Drop cloth, blanket or similar item.
12) Completely cover windshield area and front door window
openings with a drop cloth, blanket or similar item. This re-
duces the possibility of injury due to possible fragmentation of
the vehicle's glass or interior.
13) Notify all people in the immediate area that you intend to
deploy the air bag (inflator) module.
NOTE:
When the air bag deploys, the rapid gas expansion will
create a substantial report. Wear suitable ear protection.
Notify all people in the immediate area that you intend to
deploy the air bag (inflator) module and suitable ear
protection should be worn.
NOTE:
After the air bag (inflator) module has been deployed, the
surface of the air bag may contain a powdery residue. This
powder consists primarily of cornstarch (used to lubri-
cate the bag as it inflates) and byproducts of the chemical
reaction.
WARNING:
Safety precautions must be observed when handling
a deployed air bag (inflator) module.
D After deployment, the metal surfaces of the air bag
(inflator) module will be very hot. Do not touch the
metal areas of the air bag (inflator) module for
about 30 minutes after deployment.
D Do not apply water, oil, etc. to deployed air bag (in-
flator) module.
D If the deployed air bag (inflator) module must be
moved before it is cool, wear gloves and handle by
the air bag or vinyl trim.
Failure to follow procedures may result in fire or per-
sonal injury.
14) Separate the two banana plugs on the deployment harness.
15) Connect the deployment harness to the power source (12V
vehicle battery) to immediately deploy the driver or passenger
air bag.
16) Disconnect the deployment harness from the power source
(12V vehicle battery) and short the harness leads together by
fully seating one banana plug into the other.