Manual Transmission Shift Lever-Removal And Installation; T4 And T5 Shift Lever Installation Details - Jeep cherokee 1989 Owner's Manual

7A-2
2.1 1 Before loosening the retaining bolt, mark the
relationship between the speedometer adapter housing and
the transmission or transfer case with white paint
adapter is offset and must be installed in the same
relationship (retaining bolt shown removed for clarity)
. . .
then lift the adapter seal
from the inside of the housing
10 Disconnect the speedometer cable.
1 1 Mark the relationship of the speedometer adapter to the extension
12 ~ e h o v e the bolt and withdraw the adapter.
13 Install a new O-ring and adapter seal on the adapter and reinstall
the adapter and cable assembly on the extension housing (see illus-
trations).
3 Manual transmission shift lever
Refer to illustrations 3.2, 3.3, 3.5a
1 Place the shift lever in Neutral.
2 Loosen the locknut, then remove the shift knob (see illustration).
3 Use a screwdriver to disengage the boot retainer bezel from the
console, then lift off the boot (see illustration).
4 Remove the screws and lift out the center portion of the console.
5 Remove the five cover retaining bolts and lift the shift lever straight
up and out of the transmission (see illustrations). On some later models
it may also be necessary to remove a snap-ring and spring washer
before detaching the lever.
6
Installation is the reverse of removal. Tighten the shift lever cover
retaining bolts to the specified torque.
The Motor Manual Guy
Chapter 7 Part A
-
the
3.2 Loosen the locknut, then remove
the shift knob
-
removal and installation
and
Manual transmission
Use a small screwdriver t o remove the O-ring from
the groove,
KNOB
3.3
\
T 4 and T5 shift lever installation details
. . .
Use a screwdriver t o detach the
bezel from the console, then lift
the boot off