Subaru Legacy 2004 Service Manual page 1166

(3) Gradually tighten the camshaft cap and oil
control valve assembly in at least two stages in
alphabetical sequence shown in the figure, and
then tighten to the specified torque.
Tightening torque:
!
T1: 10 N m (1.0 kgf-m, 7.2 ft-lb)
!
T2: 20 N m (2.0 kgf-m, 14.5 ft-lb)
(G)
(C)
T2
(E)
(A)
(F)
(B)
T2
(D)
(H)
(4) After tightening the camshaft cap, ensure
the camshaft rotates only slightly while holding it
at "base circle".
3) Install the camshaft position sensor on exhaust
side.
Tightening torque:
!
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
4) Camshaft oil seal installation:
Apply grease to the new oil seal lips and press onto
the front end of camshaft by using ST1 and ST2.
NOTE:
Use a new oil seal.
ST1 499587600 OIL SEAL INSTALLER
ST2 499597200 OIL SEAL GUIDE
ST1
Camshaft
(L)
T1
(K)
(J)
T1
(I)
ME-00839
FU-01186
ST2
ME-00116
ME(H4DOTC)-55
5) Rocker cover installation:
(1) Install the gasket on rocker cover. Install the
peripheral gasket and ignition coil gasket.
(2) Apply liquid gasket to the designated point
of cylinder head.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
(3) Install the rocker cover on cylinder head.
Ensure the gasket is properly positioned during
installation.
(4) Tighten the rocker cover tightening bolt in al-
phabetical sequence shown in the figure, and
then tighten to the specified torque.
Tightening torque:
!
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
(C),(K)
(E)
(A),(I)
(G)
(D),(L)
MECHANICAL
ME-00776
(H)
(B),(J)
(F)
ME-00777