Chevrolet 30 Series 1967 Service Manual page 527

BRUSH HOLDER
R EM O V E BR U SH S P R IN G FR O M SLO T
A N D PLACE IT IN G R O O V E A S S H O W N
Fig. 33 - Releasing Brush Spring Tension
F ig. 34 - End P la y W a v e W asher Installation
5. Drill out gear box cover retaining rivets, remove
cover from gear train.
NOTE: Screws, nuts and lock washers for re­
assembling cover to wiper are contained in a
service repair package.
. Remove output gear and shaft assembly, then slide
6
intermediate gear and pinion assembly off shaft.
7. If necessary, remove terminal board and park switch
assembly as follows:
a. Unsolder motor leads from terminals.
motor leads is not necessary on single-speed
wipers.
b. Drill out rivets securing terminal board and park
switch ground strap to mounting plate.
NOTE:
a replacement terminal board-park switch as­
sembly
assembly.
Motor
1. Follow
disassembly.
PUMP M O U N TIN G
SCR EW S
Coding of
ELECTRICAL—BODY AND CHASSIS 12-27
Screws, nuts and washers for attaching
are included with the
Steps 1 through 7b
Fig. 36 - W asher Pump Attaching Screws
CHEVROLET TRUCK SERVICE M ANUAL
replacement
under gear box