Seats - Chevrolet 30 Series 1967 Service Manual

BODY IB-26
REINFORCEMENT..:
ASSEMBLY
RETAINER
/ SPRING
1 < / / BUMPER
GASKET
y
I
GASKET \
LOCK / \
CYLINDER \
RETAINER LOCK U N IT ^ >
t
K
*£
I j
Fig 61 - Rear Door Outside Handle
4. Connect rod through step lever with removed spring
washer and cotter pin.
5. Secure rod cover with 4 screws.
. Push pin through rod end and door.
6
7. Check door-step operation.
For adjustment, turn rod end counter-clockwise to
lengthen actuating rod; turn clockwise to shorten rod
(retract) step.
. From underside tighten 2 inboard bolts.
8
Fig. 62 - Hinge Strap and Hinge Assembly
f
1
ESCUTCHEON,
RC
D
SEMBLIES,
1
B C D __
LOWER
HANDLE -
ASSEMBLY
\ (
LOCK
SPACER
...>>

SEATS

DRIVERS (Fig. 65) AND FIXED AUXILIARY (Fig. 66)
1. Remove four bolts and lock washers and remove seat
assembly complete from vehicle. Install seat by re­
versing procedure and torquing the bolts se 'urely to
the floor with lock washers.
SEAT BACK ADJUSTMENT (Fig. 67)
Replacement
The seat back is adjustable forward or backward by
loosening the top bolts (right and left side) at the lower
side of the seat back.
OPTIONAL (FLIP-PASSENGER SEAT)
(Figs. 68 & 69)
keplacement
Remove the auxiliary seat assembly complete by re­
moving four bolts, lock washers and nuts from the seat
swivel base. The seat assembly may be removed with­
out base by lifting up and slipping off of the base.
to Figure 69.
Fig. 63 - Side Cargo Door Hinge Adjustment
(Rear Door - T yp ica l)
Refer
CHEVROLET TRUCK SLXVICE M ANUAL