Chevrolet 30 Series 1967 Service Manual page 509

5. Replace floor mat.
NEUTRAL SAFETY SWITCH REPLACEMENT
Column Shift—Switch Located on Mast Jacket
1. Disconnect wiring harness connectors at switch
terminals.
2. Remove switch retaining screws and switch from
mast jacket.
3. To install, position shift lever in drive and locate
lever tang against transmission selector plate.
4. Align slot in contact support with hole in switch and
insert pin (3/32" dia.) to hold support in place.
Switch is now in drive position.
5. Place contact support drive slot over shifter tube
drive tang and tighten screws.
pin.
Fig. 13 - Ele c tric a l Components - T ilt Cab
6
Column Shift—Switch Located on Transmission
(Fig. 15)
1. Raise and support vehicle.
2. Disconnect switch wiring from engine wiring harness
3. Remove the bolt attaching the switch to the trans­
4. Position new switch to transmission and install
5. Loosen transmission lever extension bolt and with
Remove clamp and
6
ELECTRICAL—BODY AND CHASSIS 12-9
. Connect wiring harness to terminals and check op­
eration of switch.
and remove bolt attaching the switch wiring retaining
clip to the transmission.
mission and disengage switch from shift lever rod.
switch attaching bolt.
transmission in neutral position and the switch
pinned in neutral position attach switch rod to switch.
. Tighten transmission lever extension bolt to 12-16
lbs. ft. torque and remove pin.
CHEVROLET TRUCK SERVICE MANUAL