Chevrolet 30 Series 1967 Service Manual page 76

BODY IB -14
handles. Handles are retained by clips.
2. Remove trim panel from door (fig. 31). Trim panel
is retained by four seal screws.
3. Remove trim panel shown in Figure 31 and remove
used cement with cement remover.
4 Apply cement to door groove. Then start at one end
0
of groove applying seal.
DOOR LOCKS—10-60 SERIES
The locks are of the free rotor type. They include a
safety interlock feature.
spacers should be used to insure satisfactory lock and
striker engagement.
Removal
1. Raise window.
2. Remove inside handles with Tool J-7797.
3. Remove trim panel.
4. Remove remote control sill knob.
5. From outside the door remove screws retaining lock
to door edge and lower the lock assembly.
. Remove 3 screws retaining remote control.
6
7. Remove lock, push button rod and remote control rod
as an assembly.
Installation
1. Transfer remote rod with clip to new lock.
2. Connect remote door handle rod to lock after lock is
positioned.
3. Secure lock screws.
4. Secure remote handle.
5. Check all controls for proper operation before rein­
stalling trim and handles.
„ Install remote control sill knob.
6
Front Door Lock Cylinder Assembly
Removal and Installation
1. Raise door window and remove door trim pad.
2. With a screwdriver, or other suitable tool, slide lock
cylinder retaining clip (on door outer panel) out of
engagement and remove lock cylinder.
3. To install, reverse removal procedure.
Where necessary, striker
Fig. 33 - Lock C ylin d er Installed
Front Door Lock Remote Control and Connecting Rod
The remote control is secured to the door inner panel
by the three attaching bolts.
CHEVROLET TRUCK SERVICE MANUAL