Chevrolet 30 Series 1967 Service Manual page 575

SERVICE OPERATIONS—40 THRU 60 SERIES
C A - S A 40-50-60, MA 50-60 MODELS
GRILLE REPLACEMENT (Fig. 16)
Removal
1. Remove battery from vehicle.
2. Remove front bumper (Section 14).
3. Disconnect headlamp, parking lamp, horn, and volt­
age regulator electrical connections.
4. Remove screws from each headlamp bezel and r e ­
move bezels and headlamps.
F ig . 17 - G r ille Mounting - TA Models
Fig. 16 - G r ille Mounting -
C A - S A
Remove bolts securing battery tray to grille.
5.
.
6 Remove screws, four from each side, securing skirt
to grille braces and remove braces.
Remove screws, three from each side, securing
7.
gussets to grille and fenders and remove gussets.
Remove radiator retainers from vehicle.
Remove bolts securing grille assembly to fenders,
9.
skirts, and lower panels and remove grille assembly
from vehicle.
.
10 Remove three lower panels and retainer from ve­
hicle.
40-50-60 50-60
M A Models
11. Replace mouldings, catch plate, and other grille and
mounting components as required.
Installation
Assemble and install grille and related components
following the removal procedure in reverse order. Refer
to torque specifications at rear of manual for correct
torque values.
TA MODELS (Fig. 17)
GRILLE REPLACEMENT
Removal
1. Remove headlamp bezels from grille.
2. Disconnect headlamp wiring and remove headlamps.
3. From under vehicle, remove three screws from each
side securing grille to cab face.
4. Replace grille and mounting components as neces­
sary.
Installation
Assemble and install grille assembly and related
components following the removal procedure in reverse
order. Refer to torque specifications at rear of manual
for correct torque values.
RADIATOR AND GRILLE 13-7
CHEVROLET TRUCK SERVICE MANUAL