Chevrolet 30 Series 1967 Service Manual page 137

Fig . 1 6 - Pressing Hub Bolt
square with hub flange and securely seated.
3. Place drum, deflector gasket and deflector over hub,
indexing drain holes with holes in hub. Install drum
to hub bolts and lockwashers and tighten securely.
T60 and SE531 —Figure 13
1. Brake drum is either bolted or screwed to hub de­
pending on type of wheel used. In either case, re­
move screws or bolts and separate hub and drum.
2. If necessary to replace hub bolts, press out old bolts
and press new serrated bolts into position, making
sure bolt head is square with hub flange and securely
seated. Install bolts or screws into hub and tighten
securely.
Installation
1. Pack inner and outer wheel bearings with recom­
mended grease (see Section 0).
2. Place inner bearing in hub and install new seal as­
sembly (or assem blies), tapping into place with soft
hammer.
3. Position hub on spindle and install outer bearing,
pressing it firmly into position in hub.
4. Adjust wheel bearings as outlined under Wheel Bear­
ings-Adjust.
Shock Absorbers—Figure 17
Removal
1. Remove nuts and eye bolts securing upper and lower
shock absorber eyes.
NOTE: Remove burr formed by lockwashers
on control arm and on frame.
2. Withdraw shock absorber and inspect rubber eye
bushings. If defective, replace shock absorber
assembly.
Fig. 17 - Shock Absorber Location - CP10, C20-30
Installation
Place shock absorber into position over mounting bolts
or into mounting brackets. Install eye bolts and nuts and
torque as shown in Specifications, Section 15.
COIL SPRING SUSPENSION ASSEMBLY
Front Stabilizer Bar—P-10 Figure 18
Removal
1. Raise vehicle and remove nuts and bolts attaching
stabilizer brackets and bushings at frame location.
2. Remove brackets and bushings at lower control arms
and remove stabilizer from vehicle.
Inspection
Inspect rubber bushings for excessive wear or aging -
replace where necessary. Use rubber lubricant when
installing bushings over stabilizer bar.
FRONT SUSPENSION 3-9
CHEVROLET TRUCK SERVICE MANUAL