Chevrolet 30 Series 1967 Service Manual page 458

STEERING 9-4
With Automatic Transmission
The correct end play for the shift tube is .020" mini-
COMPONENT REPLACEMENT AND REPAIRS
STEERING WHEEL
Removal
1. Disconnect directional signal switch harness from
chassis wiring harness at connector.
2. Mark steering wheel to steering shaft relationship
and remove horn button, receiving cup, belleville
spring and bushing.
3. Remove steering shaft nut and washer.
4. Use Tool J-2927 to remove wheel (fig.
necessary to tap on the bolt head of the tool with a
hammer as it is turned down, to loosen tight steer­
ing wheels.
Installation
NOTE:
Directional
must be in neutral position when assembling
steering wheel to prevent damage to cancelling
cam and control assembly.
1. With front wheels in the straight ahead position
place steering wheel on steering shaft and align.
2. Tap wheel gently into place and secure with washer
and nut.
3. Install belleville spring, receiving cup, bushings and
attaching screws.
4. Install horn button.
5. Connect directional signal switch wiring harness to
chassis wiring harness.
Fig . 8 —Steering W heel Removal
). It may be
8
signal control assembly
mum to .060" maximum between the adjusting ring and
shift lever. Also, type clamp is used in place of the
" C "
hose type at the adjusting ring.
MAST JACKET UPPER BEARING
Removal
1. Remove steering wheel as outlined in this section.
2. Remove directional signal handle by removing at­
taching screw.
3. Remove hazard switch knob from right side of turn
signal housing.
4. Remove three directional signal switch attaching
screws.
5. Guide directional wiring while pulling out directional
signal switch and bearing assembly.
. Remove bearing.
6
Installation
1. Replace all component parts in reverse order of re­
moval making sure that directional signal switch is
in neutral position before installing steering wheel.
STEERING COUPLING
Flexible Type (Fig. 9)
NOTE: Before removing the steering coupling,
either the steering gear must be lowered from
its proper position or the steering gear shaft
must be loosened and pulled upward far enough
to permit the coupling to be removed from the
wormshaft.
Removal
1. After marking wormshaft to steering shaft relation­
ship remove bolt from coupling clamp.
Fig . 9 —F le xib le Type Steering Coupling
CHEVROLET TRUCK SERVICE M ANUAL