Chevrolet 30 Series 1967 Service Manual page 73

NOTE: The striker inner edge must be paral­
lel to the striker mounting depression on the
pillar.
DOOR VENTILATOR ASSEMBLY
Removal
NOTE:
The channel between the door window
glass and door vent is removed as part of the
vent assembly.
1. Regulate the door window glass to the full down
position.
2. Remove one clip each from the door lock handle--
Tool J-7797 and window regulator handle.
3. Remove four (4) trim panel screws and trim panel.
4. Remove the bottom two screws directly below the
window regulator mechanism (fig. 24).
5. Remove three sheet metal screws at the upper front
of the door (fig. 25).
. Turn the vent assembly 90° and carefully remove by
6
guiding up and out (fig. 25).
Installation
NOTE:
Replace the door window glass and
regulate to the full down position before install­
ing the door ventilator assembly.
1. Lower the ventilator assembly into the door fram e--
center into position.
2. Make certain the rubber lip is positioned before
tightening screws.
3. Attach the two screws below the regulator assembly.
F ig . 24 - Vent Assembly Inner Door Panel Attachment
TURN 9 0
25 -
Fig. V en tila to r Assembly Removal
VENTILATOR ASSEMBLY
ADJUSTING NUT
AND TAB LOCK
F ig . 26 - Adjusting V en tila to r Operating Tension
BODY IB-11
CHEVROLET TRUCK SERVICE MANUAL