Rear Glass W I N D O W; Seats; Standard Seat - Chevrolet 30 Series 1967 Service Manual

BODY IB - 54
REAR QUARTER & REAR END
REAR WINDOW AND CORNER GLASS
Replacement
Rear window glass (and rear corner window glass-
when used) are retained by means of rubber seal and seal
insert (fig. 113). Cement butt ends of insert.
1. Pry end of seal insert out of seal with a pointed tool;
then remove rubber insert completely. Push glass
from inside cab. Pull seal from panel.
2. If necessary, straighten any irregularities of seal-
flange in cab opening which may have caused break­
age of glass.
3. Install new rubber seal over panel flange, pushing it
completely into corners.
ing installation. Cut seal to allow sufficient overlap
for a tight joint, then butt ends into position.
4. Position glass to seal and insert hook end of in­
staller Tool J-2189 (fig. 113) into seal groove. Move
tool around glass to force outer lip of seal over
glass.
5. Thread end of rubber insert through handle and loop
of installer, after applying RuGlyde or sim ilar rub­
ber lubricant to rubber insert (fig. 113).
and end of insert into groove at bottom center of
window. Feed in rubber insert while proceeding
around window. Use a hitching movement to avoid
Avoid stretching seal dur­
Push tool
elongation of insert.
. Cut off end of insert, allowing sufficient overlap for
6
a tight joint; then butt into groove. Cement butt
ends.

SEATS

Cleaning of soft trim and service of optional level ride
seat may be performed as outlined in this section under
Conventional Cabs-Seats, except that access to seat in­
stallation nuts may be gained by tilting cab.

STANDARD SEAT

Figures 114 and 115 illustrate assembly and installa­
tion of standard driver's seat. Seat track removal is
considerably eased by first removing entire seat assem­
bly from cab. Track-adjuster assembly should be lubri­
cated whenever vehicle is lubricated.
OPTIONAL AUXILIARY SEAT
The optional auxiliary seat back may be moved from in
front of the engine oil access door by raising the lower
right hand corner pivoting seat back on bolt located at
lower left hand corner.
view of auxiliary seat with seat back in position for ac­
cess to engine.
Figure 116 illustrates exploded
CHEVROLET TRUCK SERVICE M ANUAL