Chevrolet 30 Series 1967 Service Manual page 390

Chassis
Table of Contents

Advertisement

CLUTCHES AND TRANSMISSIONS 7-4
Fig. 8 - C lutch Pedal Assembly
4. Remove pedal and shaft assembly from support
bracket.
Inspection
1. Check clutch pedal bushings for excessive wear and
replace if necessary.
2. Check clutch pedal shaft for wear and alignment and
straighten or replace if necessary.
Installation
NOTE:
Use new shaft bushing if needed and
lubricate with Lubriplate or petrolatum.
1. Slide one pedal shaft bushing over shaft, install shaft
in support enough to still clear pedal bumper stop,
hook pedal return (or overcenter) spring to pedal,
then rotate pedal forward of bumper stop; slide shaft
into position in support and release pedal against
bumper stop.
2. Install clutch pedal shaft bushing over pedal shaft end
and into place in sleeve.
3. Assemble pedal push rod lever over pedal shaft and
install bolts, washers, and nut. Torque to 25 ft. lbs.
4. Adjust clutch pedal free travel as needed.
STEP VAN CLUTCH PEDAL
(Refer to Figure 9)
Removal
1. Remove upper-to-lower clutch pedal arm nut and
remove upper arm from lower arm.
2. Disconnect clutch return spring and pedal-to-cross­
shaft pull rod.
3. Remove snap ring (retaining pedal on pivot pin) and
remove pedal from pivot pin, then remove brake
pedal return spring.
4. To remove pivot shaft remove nut, washer and drive
pin from boss on bracket using a small brass driver.
5. Remove grease fitting from pivot pin, install Tool
J-8118 and use a slide hammer to remove the pin
from bracket and brake pedal.
. Inspect pin and clutch and brake pedal bushings for
6
wear and other damage.
7. If necessary to replace pedal bushings, use a cape
chisel to remove the bushing, then deburr. Install
new bushing using a vise as a press (align grease
fitting hole on brake pedal bushing).
Fig. 9 - Removing Pedal Pivot Pin
Installation
1. Install remover Tool J-8118 in grease fitting hole of
pivot pin, then align pin groove with lock pin hole and
drive pin through bracket boss and brake pedal using
slide hammer or plastic hammer.
Fig . 10 - T ilt Cab Clutch Pedal Linkage
CHEVROLET TRUCK SERVICE M ANUAL

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents