Chevrolet 30 Series 1967 Service Manual page 496

CHASSIS SHEET METAL 11-10
FRONT FENDER SKIRT
10-30 Series
Removal
1. Remove windshield wiper arms.
2. Remove cowl grille and attaching screws.
3. Remove hood and hood hinge assembly.
4. Disconnect battery and remove (right side only) or
remove skirt reinforcement at steering column (left
skirt only) (Fig. 13).
5. Remove 2 top rear fender bolts and shims.
. Remove bolt and shims at bottom of fender.
6
7. Remove bolt and shim(s) attaching skirt to sill ex­
tension.
. Remove 4 screws attaching head light door to fender
8
and grille.
9. Remove screws attaching gusset to radiator support.
10. Remove 3 screws attaching skirt to radiator support.
11. Remove 2 screws securing fender to radiator support.
12. Remove 4 screws securing fender to grille.
13. Lift fender and skirt assembly from truck.
Installation
1. Replace fender and skirt assembly.
2. Install bolts loosely.
3. Install shims and secure all parts in reverse order
of removal.
4. Tighten shimmed bolts.
FRONT FENDER SKIRT
Replacement
To replace the skirt alone, remove required screws
and rotate over tire. Reverse procedure to install.
FENDER SKIRT
40-60 Series
Removal
1. Turn steering wheel so tire front is inboard.
2. Underneath the skirt remove 2 screws at top at­
tached to fender.
F ig . 14 - Running Board and Fender Extension
(40 thru 60 Series)
NOTE Inboard nut must be
flush with last thread of brace
and outboard nut must run up
against frame to position brace
in furthest outboard position.
Fig. 15 - Running Board and Braces (CA31004 Series)
3. Remove 3 screws attaching skirt to lower fender
extension.
4. Remove 3 screws at front of skirt attached to fender.
5. Remove screws holding skirt to fender opening
6
flange.
. Remove screw attaching skirt to radiator grille.
6
Fig. 16 - Running Board and Braces
(See Illustration for Series)
FRAME SIDEMEMBER
/
f'
/
CHEVROLET TRUCK SERVICE M ANUAL