Chevrolet 30 Series 1967 Service Manual page 511

5. Use suitable pin to lock switch lever in reverse
position.
. With transmission lever in reverse position install
6
shift lever rod.
Fig. 15 - N eutral Safety Sw itch - C h evy Van
General Description.............................................................12-11
Service O p e ra t io n s ................................................... ... . 12-11
Instrument C lu ste r...................................................... ...12-11
R em oval.................. ................................................12-11
In s ta lla tio n ........................... ....................................12-11
Indicator and Illuminating Bulb R eplacem en t............ 12-12
Laminated Circuit Replacem ent................................. ...12-13
Speedometer Replacem ent........................... .. ...............12-13
Speedometer Cable Replacement
or L u b ric a t io n ......................................................... ...12-14
All instruments and gauges of the 1967 Trucks are in­
stalled in the instrument cluster.
may be removed from the vehicle for servicing of the
instruments and gauges. Illuminating and indicator lamps
may be replaced without removing the cluster from the
vehicle. On models with a laminated die cut circuit the
bulbs are installed in plastic holders which lock into the
INSTRUMENT CLUSTER
REMOVAL AND INSTALLATION
10-30 Conventional Cab Models (Fig. 17)
1. Disconnect battery ground cable.
2. Remove choke control knob.
INSTRUMENTS AND GAUGES
INDEX
GENERAL DESCRIPTION
The entire cluster
SERVICE OPERATIONS
ELECTRICAL—BODY AND CHASSIS 12-11
7. Tighten bolts to proper torque, remove pin from
switch lever and check operation of switch; lower
vehicle.
Fig. 16 - Backing Lamp Switch - C hevy Van
Fuel Gauge Replacem ent............................................. 12-14
Temperature Indicator L ig h t....................................... 12-20
Temperature Gauge R ep lacem en t.............................. 12-20
Temperature Sender Unit R ep lacem en t..................... 12-20
Oil Pressure Indicator L ig h t....................................... 12-20
Oil Pressure Gauge R ep lacem en t.............................. 12-20
Oil Pressure Sender Unit R ep lacem en t..................... 12-20
Generator Indicator...................................................... 12-20
Ammeter Gauge Replacement. .................................... 12-20
A ir Pressure Gauge R eplacem ent.............................. 12-21
cluster housing, on all other models the lamp sockets are
clip retained and can be quickly snapped in or out of
position.
Regular maintenance is not required on the instrument
cluster or its components other than maintaining clean,
tight electrical connections, replacing defective parts and
keeping the speedometer cable properly lubricated.
3. Remove windshield wiper knob and bezel nut.
4. Remove light switch rod and bezel.
5. Disconnect speedometer cable and chassis wiring
harness connector at rear of instrument panel.
. Protect mast jacket with suitable covering.
6
7. Remove cluster retaining screws from face of as­
sembly and remove cluster assembly from console.
Page
CHEVROLET TRUCK SERVICE MANUAL