Chevrolet 30 Series 1967 Service Manual page 578

BUMPERS 14-2
Fig. 3 - Front Bumper - P10 Models
each bracket) securing brackets to frame.
2. Remove left and right upper bumper connections by
removing speed nuts and plugs (one at center of each
bracket); remove lock nuts, washers, and bolts se­
curing face bar to upper brackets.
3. Remove bumper from vehicle. If necessary, re­
move lower bumper brackets from face bar by re­
moving lock nuts, washers, and bolts attaching
brackets to face bar.
Installation
Assemble and install front bumper following the re­
moval procedure in reverse order.
specifications in rear of manual for correct torque
values.
FRONT BUM PER-G MODELS (Fig. 5)
Removal
1. Remove screws securing bumper braces to frame
2. Remove bolts securing bumper face bar to frame
3. Remove bumper from vehicle.
Disassembly
1. Remove bolts attaching bumper braces to face bar
2. Remove screws securing license plate bracket to
Refer to torque
Assembly and Installation
Assemble and install front bumper following the re-
cross sill.
extensions.
and remove braces.
face bar and remove license plate bracket.
CHEVROLET TRUCK SERVICE MANUAL