FRONT SUSPENSION 3-22
necessitate replacement of axle center.
1. If kingpin holes in axle center ends are worn to such
an extent that a new standard or oversize kingpin fits
loosely, axle center must be replaced.
2. If axle center has been twisted or bent more than 5
degrees from original shape, center should be re
placed.
As a general rule, when an extreme bent
condition exists, minute fractures which may be in
visible will occur, and failure under ordinary operat
ing conditions will result. Check axle center for
twist with alignment instruments. If equipment is
available, use Magna-Flux method to check axle cen
ter for minute fractures. Axle centers should always
be straightened cold. Under no circumstances should
heat be applied.
Installation.
1. Roll axle into position, insert caster shims, and
Fig . 47 - W h e e l Bearing Cup Installers
1. J-8458 Inner Cup In staller - CP10
2. J-8849 O u ter Cup Installer - CP10
3. J-21067 Inner Cup In staller - P20-30
4. J-7585 O u ter Cup Installer - P20-30
5. J-9276-2 Inner Cup Installer - C20-30-50, 60 O uter
6. J-8457 O uter Cup In staller - C 20-30-40
7. J-21059 Inner Cup Installer - 50
8. J- 2 1 060 O uter Cup In staller - 50
9. J-21066 Inner Cup Installer - 60
10. J- 2 1 108 Inner Cup Installer - 9,000^
11. J-9276-1 O u ter Cup Installer - 9,000^
12. J- 2 1 106 Inner Cup Installer - 11,000^
13. J- 2 1 107 O uter Cup Installer - 11,000^
raise up against spring seats, making sure spring
center bolts index in spring seats.
2. Place U-bolts and U-bolt spacers over springs. In
stall shock absorber lower mounting brackets (where
used),
U-bolt
nuts
Specifications.
3. Connect shock absorber lower eye and stabilizer link
on P20-30 models.
4. Install brake backing plate assembly to steering
knuckle as outlined in Section 5 -Brakes.
5. Install steering arm and the rod assembly and torque
bolts as shown in Specifications.
. Place hub and drum assemblies over spindles and
6
adjust wheel bearings as outlined under Wheel Bear
ings-Adjust.
7. Install wheel and tire assem blies, and lower vehicle.
Check
front
end
alignment
necessary.
2
3
5
48 -
Fig.
A dditional Special Tools
1. J-6874
Spring Compressor
2. J-8092
Handle
3. J-7079-2
Handle
4. J-553
Spring Bushing Rem over/Installer
5. J-21058
Spring Bushing Rem over/Installer
J-0554
Hub Bolt Peening Tool (not shown)
and torque
as
outlined
and adjust
where
i
CHEVROLET TRUCK SERVICE M ANUAL
in