Chevrolet 30 Series 1967 Service Manual page 110

BODY IB-48
To Reposition Door Fore or Aft
NOTE: Only the upper portion of door can be
adjusted fore or aft.
at the upper hinge. No means for this adjust­
ment exists at the lower hinge.
a. Loosen upper hinge-to-door cap screws slightly.
NOTE: Access to one cap screw at door upper
hinge is gained after removing plug from door
inner panel. Use pointed tool to remove plug.
Lift upward or pull downward at rear of door to
tilt upper portion of door fore or aft as desired.
b. Tighten hinge cap screws firmly after making ad­
justment. Open and close door to check opera­
tion. Repeat adjustment if necessary. Install cap
screw access plug in door inner paneling.
c. Install striker plate assembly to cab lock pillar
as directed under "Striker Plate Adjustment."
To Reposition Door In or Out
NOTE:
Horizontal cap screw slots exist in cab
half of hinge assembly to permit this adjustment.
See Views B and E, Figure 102.
The outer surface of door when properly installed
should be flush with adjacent panel surfaces of cab (fig.
103). If necessary, reposition door as follows:
a. Loosen slightly, all cap screws which attach hinge
half to cab pillar.
b. If door is to be brought outward from cab opening,
apply pressure at door hinge area from inside
cab. If door is to be moved inward, apply pres­
sure on door outer panel at hinge area.
IMPORTANT: Excessive pressure will damage
door paneling.
This adjustment is made
«
c. After adjustment has been made, tighten hinge cap
screws firmly. Open and close door to check
operation. Readjust if necessary.
NOTE: It may be necessary to reposition door
striker plate on lock pillar after making above
adjustment.
Door Lock Striker Plate
Raised beads on the back of the striker plate and se r­
rations on both the front and back of the striker plate
spacers, coupled with movable anchor plates in the pillar,
allow for "in and out" or "up and down" adjustment for a
close fit of the door on the lock side.
The striker plate spacers must be assembled so the
vertical serrations on the spacer are toward the lock
pillar (fig. 104). Likewise, the horizontal serrations on
the lower spacer must be toward the front so they match
the horizontal slot in the striker plate.
A djustm ent
1. Position striker on pillar as low as possible (bottom
of lock rotor housing 27/32" below striker cam) and
still provide clearance between striker cam and lock
rotor leading edge.
NOTE: Striker cam must not interefere with
leading edge of rotor as door is being closed.
Outline striker with a pencil.
base from which to make further adjustment.
DOOR ASSEMBLY
Component sub-assemblies of cab doors, such as win­
dow regulator, door lock, remote control, vent window,
and door window, can be replaced without necessity of
removing door from cab. Doors can be removed, how­
ever, without prior removal of above components. Re­
moval and installation of door window glass is described
under Door Window Glass.
Fig. 104 - Door Lock Striker Plate
This will provide a
CHEVROLET TRUCK SERVICE MANUAL