Chevrolet 30 Series 1967 Service Manual page 27

F ig . 35 - T ilt Cab M odels
Figure 35 shows the differences between the tilt cab
and the conventional truck lubrication chart.
1. Steering Gear - The filler plug is located behind the
steering gear shaft.
2. Tilt Cab Body Hinges - Each hinge should be lubri­
cated through a fitting with chassis lube every
miles.
3. Tilt Mechanism Check Link - Every 6,000 m iles, a
small amount of lubriplate or equivalent should be
applied to the check link and roller.
4. Tilt Cab Operating Controls - The operating con­
trols and levers at the rear of the cab should be
lubricated at each pivot or bearing point with a
small amount of engine oil every 6,000 miles.
additional lube fitting is provided on the hold-down
catch pivot. This should be lubricated every 6,000
miles with chassis lubricant.
LUBRICATION 0-25
6 , 0 0 0
An
CHEVROLET TRUCK SERVICE MANUAL