Chevrolet 30 Series 1967 Service Manual page 495

17. Tighten right fender skirt front 3 bolts from under­
side to radiator support.
18. Place battery tray in position and fasten to radiator
support.
19. From beneath skirt fasten screw to battery tray
bottom.
20. Install bolt and shim loosely bottom of front fender
rear to hinge pillar.
21. Tighten grille filler panel screws previously at­
6
tached to radiator support.
22. Install radiator, hoses and shroud.
23. Connect removed wiring to radiator support.
24. Install both head lamp assemblies.
25. Tighten all previously installed bolts, screws loosely
attached.
26. Install battery and connect leads and wires.
27. Fill radiator with coolant as specified in Section 13.
28. Install hood on previously marked outline.
29. Install and secure cowl grille.
30. Install windshield wiper arm assemblies.
FRONT FENDER
10 thru 30 Series
Removal
1. Remove windshield wiper arms, cowl grille and at­
taching screws.
2. Remove hood and hinge assembly.
3„ Remove head lamp door, wiring and attachments
from fender.
4. Remove screws attaching fender wheel opening flange
to skirt.
5. Remove 2 skirt to fender bolts, located inboard on
underside of skirt.
. Remove two screws attaching gusset to fender.
6
7. Remove two screws attaching radiator support to
front fender.
. Remove four bolts attaching radiator grille to fender.
8
9. Remove bolt and shim attaching to trailing edge of
fender to hinge pillar.
Fig. 13 - Front Fender and Skirt Attachment (10 thru 30 Series)
10. Remove two bolts and shims at top rear of fender
attaching to cowl.
Installation
To install, reverse the removal procedure using seal­
ing tape between filler panel and fender. Check sheet
metal alignment.
40 thru 60 Series
Removal
1. Remove windshield wiper arms.
2. Remove cowl grille--disconnecting radio antenna
lead.
3. Remove hood, outlining hinge bolts at fender before
removing.
4. Lift hood off.
5. Remove two bolts and shims attaching fender to cowl.
. Remove 1 screw from inside cab (plastic plug covers
6
access mounting). (Do not remove cowl bracket.)
7. Remove screws connecting skirt edge to fender
flange.
. Right fender removal necessitates removal of battery
8
cables, battery and three screws attaching battery
tray to fender.
9. Remove 1 bolt hidden from view connecting grille
lower panel to front inboard edge of fender (access
hole provided).
10. Remove bolts connecting grille to front fender from
inside of engine compartment.
11. Remove 3 bolts fastening gusset to fender and grille
(fig. ).
1 2
12. Remove two bolts fastening gusset to fender.
13. Remove all electrical connections.
Installation
To install, reverse the removal procedure using seal­
ing tape between filler panel and fender. Check sheet
metal alignment.
CHASSIS SHEET METAL 1
CHEVROLET TRUCK SERVICE M ANUAL