Chevrolet 30 Series 1967 Service Manual page 510

ELECTRICAL—BODY AND CHASSIS 12-10
HORN
RELAY
7. Connect switch wiring to engine wiring harness and
install wiring retaining clip bolt.
. Check operation of switch and lower vehicle.
8
BACKING LAMP SWITCH REPLACEMENT
Switch Located on Mast Jacket (Fig. 13)
1. Disconnect wiring at switch terminals.
2. Remove switch attaching screws and switch from
mast jacket.
3. Position replacement switch to mast jacket, install
retaining screws and connect wiring to switch
terminals.
BACKING —
LAMP SWITCH
DIMMER-
SWITCH
Fig. 14- Ele c tric a l Components - C onv. Cab
STOPLIGHT
SV/ITCH
AIR BRAKE —
WARNING BUZZER
NOTE: Position gear shift in neutral before
assembling switch to mast jacket.
4. Check operation of switch.
Switch Located on Transmission Side Cover (Fig. 16)
1. Raise and support vehicle.
2. Disconnect wiring at switch terminals.
3. Remove two bolts attaching switch and switch wiring
retaining clip to transmission side cover; disengage
switch from shift lever rod.
4. Mount replacement switch loosely to transmission
side cover and connect wiring to switch terminals.
HORN RELAY
STOPLIGHT
i SWITCH
CHEVROLET TRUCK SERVICE MANUAL