Chevrolet 30 Series 1967 Service Manual page 577

General Description......................................................... 14-1
Service Operations - 10 thru 30 Series
Front Bumper - C and K M o d e l s .............................. 14-1
Rear Bumper - C and K M o d e ls .................................
Front Bumper - P10 M o d e l s .................................... 14-1
Front Bumper - P 20 and P30 Models
SERVICE O PERA TIO N -10 THRU 30 SERIES
FRONT BUMPER-C AND K MODELS (Fig. 1)
Removal
1. Remove bolts securing left and right bumper braces
to frame.
2. Remove bolts securing two bumper brackets to
frame.
3. Remove bolts securing bumper face bar to frame,
and remove bumper from vehicle.
4. If necessary, disassemble bumper by removing bolts
attaching brackets and braces to bumper face bar.
Installation
Assemble and install front bumper following the re­
moval procedure in reverse order.
specifications in rear of manual for correct torque
values.
REAR BUMPER-C AND K MODELS (Fig. 2)
Removal
1. Remove bolts attaching bumper to each bumper
bracket.
2. Remove bolts attaching bumper to frame.
3. Remove bumper from vehicle.
4. If necessary, replace body dirt seal.
F ig . 1 - Front Bumper - C and K Models
SECTION 14
BUMPERS
INDEX
Page
........................ 14-1
14-1
...................... 14-1
GENERAL DESCRIPTION
All 1967 truck front and rear bumpers are of a single
piece design. Bumper attachments are the standard
bracket and brace to frame mountings. This section
contains procedures for the removal and installation of
face bars, brackets, braces and license plate brackets.
Refer to torque
Front Bumper - G Models
Rear Bumper - G M o d e ls ................................................ ..... 14-3
Service Operations - 40 thru 60 S e r i e s ..................... .. ........... 14-3
Front Bumper - C, S, M 40, 50, 60 and P40
M o d e ls ........................................................................... ..... 14-3
Front Bumper - T M o d e l s ............................................. ..... 14-3
Installation
Install rear bumper following removal procedure in
reverse order. Refer to torque specifications in rear of
manual for correct torque values.
FRONT BUMPER—P I0 MODELS (Fig. 3)
Removal
Remove nuts, washers, and bolts securing front bumper
to forward frame horns and remove bumper from vehicle.
Installation
Place bumper in mounted position and secure to frame
with bolts, washers, and nuts. Refer to torque specifi­
cations in rear of manual for correct torque values.
FRONT BUMPER—P20 AND P30 MODELS (Fig. 4)
Removal
1. Remove left and right lower bumper brackets by
removing speed nuts and plugs (one at center of
Fig . 2 - Rear Bumper - C and K Models
............................................. ..... 14-2
CHEVROLET TRUCK SERVICE MANUAL