17,000 Lb. Axle - Chevrolet 30 Series 1967 Service Manual

REAR SUSPENSION AND DRIVE LINE 4-28
5. Install new hub cap-to-hub gasket, position hub cap to
hub and install attaching bolts—torque bolts to 14 ft.
lbs.

17,000 LB. AXLE

1. Remove the axle shaft flange-to-hub retaining nuts.
(Refer to Figure 57.)
2. Strike the center of shaft flange with a lead hammer
1. A x le Shaft
2 . A x le Shaft-to-W heel Bolt
3. Adjusting N u t Lock N u t
4 . Hub O uter Bearing Assembly 10. O il Seal
5 . Hub O uter Bearing Retainer
6. W h eel Bolt
Fig. 57 - Hub and Drum Details (Nondemountable - Type Drum)
7. Drum 12. Drum-to-Hub Retaining
8. O il Deflector Screw
9. O il Deflector 13. Thrust Washer
14. Bearing Adjusting N ut
11. Hub Inner Bearing 15. Adjusting N u t Lock
Assembly 16. G asket
to loosen flange and dowels.
3. Remove tapered dowels from studs and pull axle
shaft from housing. In some instances it may be
necessary to spread dowels to permit removal.
4. Thoroughly clean old gasket material from wheel hub
and axle shaft flange, and install a new gasket over
hub studs and against hub.
5. Install axle shaft so that splines are aligned with dif-
17. A x le Shaft Thrust
Spacer
18. Hub Cap
19. Hub Cap Retaining
Bolt
20. O il Seal
21. W h ee l Stud
22. Drum-to-Hub Retaining Bolt
23. Tapered Dowel
24. Axle-to-H ub Retaining Stud
25. A x le Shaft-to-Hub Retaining
N ut
CHEVROLET TRUCK SERVICE MANUAL