Chevrolet 30 Series 1967 Service Manual page 498

CHASSIS SHEET METAL 11-12
V IE W A
TT40, TD-TG50-60
Fig. 19 - Designation and Name Plates
The Chevy Van sheet metal consists of the radiator air
deflector, splash shields and the engine cover.
SPLASH SHIELDS AND RADIATOR AIR DEFLECTOR
Removal and Installation
The radiator air deflector (figs. 21 and 22) is attached
to the underside of the body forward of the radiator.
air deflector may be removed by first removing the right
and left side splash shields and then removing the deflec­
tor attaching screw and plain washers. Upon installation,
make certain that all screws are installed and torqued
sufficiently to eliminate rattles or wind vibration.
F ig . 21 - Radiator A ir Deflector and Splash Shields
V IE W B
CHEVY VAN AND SPORTVAN
Fig. 20 - Front End Access Panel and Emblem
ENGINE COMPARTMENT COVER ASSEMBLY
(Fig. 23)
Removal
1. Disengage the clamp at the front of the cover and re­
move the nut, washers and bolt from the check
assembly.
2. Remove hinge pins attaching the rear hinges to the
The
compartment and remove cover.
Installation
1. Position the cover on the compartment and align
hinges with holes. Install the hinge pins at the hinge
locations.
2. Install the check assembly, then install the bolt,
washers and nut.
3. Adjust the cover if required (fig. 23) by moving the
hinge in the elongated holes to insure a tight fitting
cover. Torque all bolts.
F ig . 22 - Installing Radiator A ir Deflector
CHEVROLET TRUCK SERVICE MANUAL