Chevrolet 30 Series 1967 Service Manual page 313

Fig. 12V—C entering Tool in C over (366)
. Install fan belt and adjust to specifications using
6
strand tension gauge.
7. F ill cooling system, start engine and check for leaks.
Crankcase Front Cover
Removal
1. Remove oil pan as outlined.
2. Remove torsional damper as outlined.
3. Remove water pump as outlined in Section
4. Remove crankcase front cover attaching screws
and remove front cover and gasket, then discard
gasket.
Installation
cu.
2 8 3 an d 3 2 7 in. Engines
1. Make certain that cover mounting face and cylinder
block front end face are clean and flat.
2. Coat the oil seal with engine oil and using a new
cover gasket, coated with gasket sealer install cover
and gasket over dowel pins and cylinder block.
3. Install cover screws and torque to specifications.
4. Install water pump as outlined in Section
5. Install torsional damper as outlined.
. Install oil pan as outlined.
6
366 cu. in. Engines
1. Make certain that cover mounting face and cylinder
block front end face are clean and flat.
2. Coat the oil seal with engine oil and install Aligning
Tool J-22102 in oil seal (fig. 12V) then using a new
cover gasket coated with gasket sealer, install cover
and gasket on cylinder block.
3. Install cover screws and torque to specifications.
Then remove Aligning Tool J-22102.
4. Install water pump as outlined in Section
5. Install torsional damper as outlined.
. Install oil pan as outlined.
6
Fig. 13V—Installing O il Seal (C o ver Removed) 283 and 327
Oil Seal
Replacement
With Cover Rem oval
1. With cover removed, pry old seal out of cover from
the front with a large screw driver.
2. Install new seal so that open end of the seal is toward
K.
6
the inside of cover and drive it into position with
Tool J-9 95 on 283 and 327 cu. in. engines (fig. 13V)
or Tool J-22102 on 366 cu. in. engines (fig. 14V).
CAUTION:
J-971 may be used as support.)
K.
6
K.
6
Fig . 14V—Installing O il Seal (C over Removed) 366
Support cover at seal area. (Tool
CHEVROLET TRUCK SERVICE MANUAL
ENGINE 6-33