Chevrolet 30 Series 1967 Service Manual page 135

lb. axles, tie rod sockets should both be tilted in the same
direction, forward or rearward, before tightening clamp
bolts (fig. ).
1 2
Cornering Wheel Relationship
Cornering wheel relationship, or toe-out on turns is
determined by the angle of the steering arms. If, when
checking this angle, toe-out does not fall within specified
lim its, it will be necessary to replace defective steering
arm as outlined under Steering Knuckle/Steering Arm
later in this section.
Steering Axis or Kingpin Inclination
Steering axis or kingpin inclination is the tilt of the
steering knuckle kingpin. If the inclination is not within
the specified lim its, the steering knuckle is bent and must
be replaced on IFS models; on I beam axle models, the
axle center is bent and must be repaired as outlined un­
der Front Axle Repair later in this section.
F ig . 13 - Wheel Hubs and Bearings
FRONT SUSPENSION 3-7
CHEVROLET TRUCK SERVICE M ANUAL