Chevrolet 30 Series 1967 Service Manual page 112

BODY IB -50
1. Vent W indow Glass
2. Division Channel
3. Access Panel
4. Remote Control
H andle
5. Remote Control Attaching
Screws
5. When installed, bottom of glass must be centered in
glass regulator channel (fig. 109). P ress glass with
filler into channel until firmly seated.
. Position glass assembly into opening at bottom of
6
door (fig. 108) and engage edges of glass in door
front and rear glass run channels.
7. Engage regulator arm pin in glass channel with
leather washer located each side of channel as shown
in Figure 110. Install pin fastener (View B, fig. 106).
. Raise window, then referring to Figure 106, engage
8
lug of sash run channel into slot of run channel re­
tainer. Install two screws into holes (fig. 106) at­
taching retainer to door edge framing.
9. Raise and lower door window to check for binding. If
INTERIOR OF DOOR
Fig. 105 - Door Assembly
6. W eatherstrip Seal C lip
and Screw
7. Weatherstrip Seal
8. Access Panel
9. Division Channel Lower
A ttaching Screws
10. Regulator A ttaching Screws
Regulator Handle
11.
12. Division Channel Upper
A ttaching Screws
13. Door W indow Sash
14. Sash Channel
15. Door Lock Remote Control
Assembly
binding exists, division channel attaching screws (9
and ) should be loosened to allow channel to shift
2 1
for free operation of window. Retighten screws after
making adjustment.
10. Install access panel (
DOOR VENT GLASS
NOTE:
This procedure covers replacement of
the vent glass only.
Removal
1. Remove small access panel from inner side of door
below vent window.
removed.
DOOR CONSTRUCTION
16. Door Lock Mechanism
17. Run Channel Retainer Screws
18. Run Channel Retainer
19. Door W indow Stop Bumper
20. W indow Regulator Assy.
21.
Division Channel Center
Attaching Screw
), to opening at bottom of door.
8
Figure 111 shows access panel
CHEVROLET TRUCK SERVICE MANUAL