Chevrolet 30 Series 1967 Service Manual page 392

CLUTCHES AND TRANSMISSIONS 7-6
F ig . 13 - Installing Snap Ring in G ro o ve
3. Install snap ring (piston retainer) as shown in Fig­
ure 13.
4. Install boot over push rod (fig. 14) and install push
rod and boot to slave cylinder.
Installation
1. Bolt slave cylinder assembly to engine clutch housing
(fig. 3).
2. Adjust slave cylinder push rod clearance, as outlined
in this section, under "Clutch Pedal Total Travel."
3. Attach hydraulic line to slave cylinder and bleed air
from system at slave cylinder bleed fitting.
Fig. 14 - Installation of Slave C ylin d er Boot
CLUTCH CROSS-SHAFT (Fig. 15)
Removal
1. Disconnect clutch fork return spring at fork.
2. Disconnect pedal push rod at cross-shaft lever and
allow clutch fork push rod to hang free from lower
lever.
3. Loosen ball stud nut and slide stud out of bracket
slot, then lift cross-shaft off engine ball stud and out
of vehicle.
4. Remove clutch fork push rod from cross-shaft lever
if necessary.
5. Reverse removal procedure to install.
CHEVROLET TRUCK SERVICE M ANUAL