Windshield Wipers; Emblem Assembly And Front Access Panel; Instrument Panel Compartment - Chevrolet 30 Series 1967 Service Manual

WINDSHIELD WIPERS

Two separate motors are used to power the wipers on
Tilt Cab Trucks, one switch controlling both. Covered
here will be removal and installation of the units on the
98 -
Fig. Fresh A ir
INTERIOR VENT
AND CONTROL
Fig. 97 - Fresh A ir Flow
Vent
Assy.
vehicle only. Repair of wiper motors, etc. will be found
in Section 12, E lectrical.
of the left hand wiper assembly installation. Right hand
assembly is identical; however it will be necessary to
remove heater assembly before wiper motor may be
serviced.
Removal
1. Remove positive cable from battery terminal.
2. Remove nut retaining wiper onto shaft.
3. Pull arm, knurled driver and rain shield from shaft.
4. Remove nut retaining shaft ferrule to body outer
panel; remove washers.
5. From inside vehicle, remove four screws retaining
motor assembly to dash and remove assembly from
vehicle.
Installation
Install by following removal procedure in reverse
order. After connecting battery, test operation of wipers
thoroughly.
EMBLEM ASSEMBLY AND FRONT
ACCESS PANEL
Figure 100 illustrates installation of both the emblem
and access panel. The panel must be removed to gain
access to emblem retaining nuts. The panel also serves
as the air inlet grille for the ventilating system and is
fitted with a screen which should be checked periodically
and cleaned if necessary.

INSTRUMENT PANEL COMPARTMENT

Figure 101 illustrates installation and assembly details
of the instrument panel compartment. Note that if truck
is equipped with heater, it will be necessary to remove
BODY IB-45
Figure 99 is an exploded view
CHEVROLET TRUCK SERVICE M ANUAL