Chevrolet 30 Series 1967 Service Manual page 457

DO N O T M ISA LIG N
M ORE THAN O N E
INCH FROM VERTICAL
Fig. 4 —Steering W h e e l Alignm ent
number of turns or in different directions will
disturb the toe-in setting of the wheels.
4. R e a d j u s t toe-in as
necessary).
Steering Wheel Alignment
NOTE:
On C-P10-C20-30 series units check
steering gear for high point centering before
checking steering wheel alignment.
1. Set wheels in straight ahead position by driving
vehicle a short distance.
2. Note steering wheel position. If off more than 1 inch
Fig . 5 —Steering W heel Alignment
outlined in Section 3 (if
6-10-20-30
Fig. Lower Bearing Adjustment
from center (figs. 4 & 5), remove steering wheel and
reposition.
Mast Jacket Lower Bearing Adjustment
1. Loosen clamp on steering shaft.
2. Adjust clamp to allow steering shaft end play indi­
cated in specifications section.
NOTE:
On 10, 20 and 30 Series trucks check
distance from top edge of washer to lower edge
of bearing (fig. ).
6
3. Tighten clamp bolt.
Shifter Tube Adjustment
3-Speed Transimission
1. Loosen adjusting ring attaching screws and clamp
bolt.
2. Rotate adjusting ring to give .005" end play between
adjusting ring and first and reverse shifter lever
(fig. 7).
3. Tighten attaching screws and clamp bolt.
F ig . 7 —Checking Adjusting Ring C learance
STEERING 9-3
CHEVROLET TRUCK SERVICE MANUAL