Chevrolet 30 Series 1967 Service Manual page 571

2. Remove bolts attaching air deflector to radiator
support, frame, and body and remove air deflector.
(Refer to Figure 4.)
3. Remove bolts attaching left and right splash shields
to frame and remove splash shields.
Figure 4.)
Drain radiator and disconnect radiator hoses and
transmission coolant line if so equipped.
5. Remove screws attaching shroud to radiator supports
and baffle and carefully hang shroud over engine fan
assembly to provide clearance for radiator removal.
. Remove radiator attaching screws and lower radiator
6
from vehicle. Remove shroud from vehicle.
7. Install shroud and radiator following the removal
procedure in reverse order.
and transmission coolant line, fill cooling system,
and check for leaks. If no leaks are present, install
air deflector and splash shields.
SERVICE OPERATIONS—40 THRU 60 SERIES
NOTE: CA-SA40,
CE-ME-SA60 trucks
shroud as shown in Figure 7. Radiator r e ­
placement procedures for these vehicles include
replacement of the shroud as illustrated.
CA40, CE-CS-MA-SA50, CE-CS-SA60
MODELS (Fig. 8)
Radiator Replacement
1. Drain radiator and disconnect water hoses and trans­
(Refer to
Connect radiator hoses
CS-CE-CD-MA-SA50, CS-
are equipped with fan
F ig. 5 - Radiator and Shroud Mounting - G E Models
Fig. 6 - Radiator and Shroud Mounting - G S Models
mission coolant line if so equipped.
2. If vehicle is equipped with a fan shroud, remove
shroud attaching screws (fig. 7) and carefully hang
shroud over engine fan assembly to provide clearance
for radiator removal.
3. Remove screws securing
radiator support and
bumpers.
4. Lift radiator up out of lower mounts. Lift shroud
out of vehicle if applicable.
RADIATOR AND GRILLE 13-3
radiator retainers to
remove retainers and
CHEVROLET TRUCK SERVICE M ANUAL