Chevrolet 30 Series 1967 Service Manual page 415

1. P ress or drive oil seal (22) out of remote control
cover (5) bore.
2. With a suitable sleeve, press or drive new oil seal
(22) into bore of cover (5) flush.
Remote Control Assembly
Key Numbers in Text Refer to Fig. 4K
NOTE: On transmissions having remote con­
trols only, accomplish the following procedures:
1. Insert remote control shift rail (2) part way into
cover (5), with flat on rail toward gasket face.
2. Position shift finger (23) on shift rail (2) with off-
center hole to front. Push shift rail the remaining
distance into cover.
3. Install roll pin (24) retaining shift finger (23) on shift
rail ( ).
2
4. With locknut ( ) installed on shift yoke guide (7),
6
install guide in cover (5). Tighten locknut firmly.
1. 3rd and 4th
Shift Fork
2. Lock Pins
3. Reverse Shift Lug
Fig. 5K - Transmission C o ver Assembled
4. Reverse Shift
Rai I
5. Rail Interlock Pin
6. Reverse Shift Fork
5. Install snap ring (19) in groove of shift rail (2). In­
stall new O-ring seal (
snap ring.
. Install new shift rail boot (
6
( ) on shift rail ( ).
2 1 2
7. Position shift rail yoke (9) and rail selector (12)
(with offset toward front) on yoke guide (7) and shift
rail ( ).
2
. Install retaining pin (14) into holes in rail selector
8
( ) and shift rail ( ).
1 2 2
9. Install ball joint assembly (13) on rail selector (12)
retaining with nut (
1 0
NOTE:
The word "L E F T " on ball joint assem ­
bly goes down.
10. Install bell crank (17) on ball joint assembly (13)
attaching with nut (16) and lock washer (15).
11. Install expansion plug (1) in shift rail opening in
cover (5).
7. Transmission Cover
8. W e lc h (Expansion)
Plugs
9. 1st and 2nd Shift Fork
CLUTCHES AND TRANSMISSIONS 7-29
) on shift rail against the
2 0
) with new retaining ring
8
) and lock washer ( ).
1 1
10.~Rail Interlock Plungers
11. 3rd and 4th Shift Rail
12. 1st and 2nd Shift Rail
13. 1st and 2nd Shift Lug
CHEVROLET TRUCK SERVICE MANUAL