Chevrolet 30 Series 1967 Service Manual page 488

CHASSIS SHEET METAL 11-2
Figures 1 and 2 show a typical front sheet metal as­
sembly for 10 thru 30 and 40 thru 60 series vehicles,
respectively. The 1967 sheet metal design includes fewer
service parts and an easier replacement for service pur­
poses. A complete redesign of front end sheet metal
includes removal of lights from the hood, elimination of
the upper fender extension,
elimination of the radiator support on 40 thru 60 series
trucks, and other design improvements of individual
GENERAL DESCRIPTION
a one piece fan shroud,
F ig . 2 - Front End Sheet Metal - 40 thru 60 Series Trucks
assemblies.
The following pages contain servicing information for
removal, assembly and adjustment of front sheet metal
components. The Conventional Truck sub-section may be
considered the basic write-up of the entire section. Any
component found on other series trucks which is not
covered in that section may be serviced as is explained
for its counterpart in the Conventional Truck sub-section.
CHEVROLET TRUCK SERVICE M ANUAL