Chevrolet 30 Series 1967 Service Manual page 109

To Reposition Door Up or Down
NOTE: Door raised adjustment is limited by a
striker at top rear of door (View A, fig. 102).
The striker support at cab is mounted over a
shim which will usually provide the proper
clearance at top of door; however, shim can be
removed or another added as desired.
a. Loosen hinge-to-door cap screws slightly. Re­
position door on hinges to provide equal clearance
around perimeter of door in cab opening.
V I E W A — D O O R U P P E R S U P P O R T
V I E W F— LO C K ST R IK ER P LA T E
A N D L O W E R ST R IK ER S U P P O R T
NOTE:
hinge is gained after removing plug from door
inner panel. Use pointed tool to remove plug.
b. After satisfactory adjustment has been obtained,
tighten hinge cap screws firmly. Open and close
door to check operation. If necessary, repeat
adjustment. Install hinge cap screw access plug
in door inner panel after making final adjustment.
c. Install striker plate assembly on cab lock pillar
as directed under "Striker Plate Adjustment."
C O W L HALF
A D JU S T M E N T
V I E W B — D O O R U P P E R H IN G E
D O O R HALF
A D JU S T M E N T
V I E W E— D O O R L O W E R H IN G E
Fig. 102 - Door Adjustment Points
Access to one cap screw at door upper
...... ~
5 STRIKER
a .,,..— ,,,,,..
V IE W C— D O O R U P P E R ST R IK ER
STRIKER
V I E W D— D O O R L O W E R ST R IK ER
CHEVROLET TRUCK SERVICE M ANUAL
BODY IB-47