Chevrolet Cruze 2012 Manual page 1137

BACK TO CHAPTER INDEX
Fixed and Movable Windows
Special Tools
• BO-46974 Glass Removal System
• BO-641 Suction Holder
For equivalent regional tools, refer to
Removal Procedure
Warning: Refer to Cracked Window Warning
Warning: Refer to Glass and Sheet Metal Handling Warning
Note: Position the vehicle on level ground and move the front wheels to the straight-ahead position.
1. Disconnect battery.
2. Remove air inlet grille panel. Refer to
3. Remove windshield garnish molding. Refer to
4. Remove inside rearview mirror. Refer to
5. Use BO-46974 system to remove the windshield.
Warning: Refer to
6. Take the diagonal measurement of the windshield.
7. Cut cutting wire into four times lengths.
Ca. 6200 mm (244.093 in), the circumference of the corresponding roll of wire is approximately 1000 mm (39.369 in).
8. Heat the awl with a suitable tool.
9. Stick the awl (1) with adhesive bed in the area of the front wall.
Ensure that the windshield is not damaged in the process, otherwise stress cracks in the windshield may occur.
10. Pull the wire through.
• Thread the cutting wire into the hole of the awl and bend it over.
• Pull the cutting wire with the awl to the middle of the steering wheel in the interior.
Special Tools.
in the Preface section.
Air Inlet Grille Panel
Windshield Garnish Molding
Inside Rearview Mirror
Defroster Outlet Warning in the Preface section.
BODY SYSTEMS
in the Preface section.
Replacement.
Replacement.
Replacement.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 04
TO MODEL INDEX