Chevrolet Cruze 2012 Manual page 1277

BACK TO CHAPTER INDEX
Wipers and Washers
Callout
Windshield Washer Arm Finish Cap
Tip
Use a small flat-bladed tool to remove finish cap.
1
Special Tools
BO-6626 Wiper Arm Puller
For equivalent regional tools, refer to
Windshield Washer Arm Nut
Caution: Refer to
Procedure
1. Locate the transparent circle with a black dot in the center at the lower windshield blackout area.
2. Position the wiper arm to the pivot shaft so that the wiper blade is centered across the transparent circle.
2
3. Lift the arm blade portion while pushing down the arm onto the pivot shaft.
4. Install the wiper arm nut.
5. Hold the wiper arm stationary in position as previously stated.
6. Torque the wiper arm nut.
7. Release the wiper arm assembly.
8. Repeat the same procedure for the other wiper arm.
Tighten
24.5 N·m (18 lb ft)
Windshield Washer Arm Assembly
3
Tip
Use the wiper arm puller if the arm fails to release from the wiper motor pivot shaft.
Special Tools.
Fastener Caution in the Preface section.
BODY SY S T E M S
Component Name
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 04
.
TO MODEL INDEX