Chevrolet Cruze 2012 Manual page 724

BACK TO CHAPTER INDEX
Air/Wind and Noise
Clean the weatherstrips and the contact surfaces with cleaning solvent.
1. Apply powder or chalk in an unbroken line to the contact surface of the weatherstrip surrounding the perimeter of the suspected
areas.
2. Close the panel completely without slamming the panel. Closing the panel completely presses the weatherstrip firmly against the
mating surface.
3. Inspect the applied line on the weatherstrip. The applied line is marred where contact is good. A corresponding imprint is on the
mating surfaces.
4. Gaps or irregularities in the powder or the chalk line on the mating surfaces indicate the areas with a poor seal.
GENERAL INFORMATION
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Section 01
TO MODEL INDEX