Chevrolet Cruze 2012 Manual page 1394

BACK TO CHAPTER INDEX
Supplemental Inflatable Restraints
11. Twist together the 2 connector wire leads from the high circuits from both stages of the steering wheel module, to one set of
deployment wires. Refer to
12. Inspect that the 3-wire connection is secure.
13. Secure and insulate the 3-wire connection to the deployment harness using electrical tape.
14. Twist together the 2 connector wire leads from the low circuits from both stages of the steering wheel module, to one set of
deployment wires. Refer to
15. Inspect that the 3-wire connection is secure.
16. Secure and insulate the 3-wire connection to the deployment harness using electrical tape.
17. Connect the deployment harness to the connector on the steering wheel module.
18. Route the deployment harness out of the driver side of the vehicle.
19. Disconnect the yellow left roof rail harness connector from the vehicle harness connector.
20. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
21. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
22. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gauge) or thicker multi-strand wire. These wires will be used to fabricate
the roof rail air bag deployment harness.
23. Strip 13 mm (0.5 in) of insulation from both ends of the wires.
24. Twist together one end from each of the wires in order to short the wires.
25. Twist together one connector wire lead to one deployment wire.
26. Secure and insulate the connection using electrical tape.
27. Twist together and tape the remaining connector wire lead to the remaining deployment wire.
28. Connect the deployment harness to the yellow connector of the roof rail module.
29. Route the deployment harness out of the driver side of the vehicle.
30. Disconnect the instrument panel module yellow harness connector (1) from the vehicle harness connector (2).
Note: If the vehicle is equipped with dual stage air bags the steering wheel module and instrument panel module will each have
4 wires. Refer to
31. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
32. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
Component Connector End Views
Component Connector End Views
Component Connector End Views
RESTRAINTS
in order to determine the correct circuits.
in order to determine the correct circuits.
for determining high and low circuits.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 08
TO MODEL INDEX