Chevrolet Cruze 2012 Manual page 1459

BACK TO CHAPTER INDEX
Front Suspension
2. Install the insulator clamp to the insulator:
2.1. Position the clamp (2) over on the insulator.
2.2. Use two M8 bolts (1, 3) with 40 mm (1.57 in) length.
2.3. Tighten bolts (1, 3) by turns until clamp (2) slips over insulator.
3. Check proper fitting of clamp and insulator.
Retainer (1) MUST seat centrically in the hole of the clamp.
Caution: Refer to
4. Install the NEW stabilizer shaft bolts (1) and tighten the NEW stabilizer shaft bolts to 22 N·m (17 lb ft) + 40° using the EN 45059
kit .
Fastener Caution in the Preface section.
SUSPENSION
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
TO MODEL INDEX