Chevrolet Cruze 2012 Manual page 1427

BACK TO CHAPTER INDEX
Power Steering
Special Tools
CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod
For equivalent regional tools, refer to
Removal Procedure
1. Raise and support the vehicle. Refer to
2. Remove the tire and wheel assembly. Refer to
3. Remove the steering linkage outer tie rod. Refer to
4. Remove the steering gear boot. Refer to
5. Remove the steering linkage inner tie rod with CH-6247 remover/installer .
Installation Procedure
1. Apply threadlock compound to the threads of the inner tie rod.
Caution: Refer to
2. Install the steering linkage inner rod using the CH-6247 remover/installer and tighten to 90 N·m (64 lb ft).
3. Install the steering gear boot. Refer to
4. Install the steering linkage outer tie rod. Refer to
5. Install the tire and wheel assembly. Refer to
6. Measure the wheel alignment. Refer to
7. Adjust front toe. Refer to
8. Center the steering angle sensor. Refer to
Special Tools.
Lifting and Jacking the
Tire and Wheel Removal and
Steering Gear Boot
Fastener Caution in the Preface section.
Steering Gear Boot
Tire and Wheel Removal and
Wheel Alignment
Wheel Alignment - Steering Wheel Angle and/or Front Toe
Steering Angle Sensor
STEERING
Vehicle.
Installation.
Steering Linkage Outer Tie Rod
Replacement.
Replacement.
Steering Linkage Outer Tie Rod
Installation.
Measurement.
Centering.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Replacement.
Replacement.
Adjustment.
TO MODEL INDEX
S e c tion 09