Chevrolet Cruze 2012 Manual page 1391

BACK TO CHAPTER INDEX
Supplemental Inflatable Restraints
11. Extend the SIR deployment harness and adapter to the full length from the deployment fixture or area.
Note: On a dual stage inflator module, both connectors must be attached to the deployment harness adapter. This will ensure that
both stage 1 and stage 2 of the deployment loops are energized, regardless of the deployment state.
12. Connect the inflator module (1) to the adapter (2) on the SIR deployment harness (3).
Note:
• The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the immediate area
that you intend to deploy the inflator module.
• When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of
the inflator module due to the force of the rapid expansion of gas inside the inflator module.
• If you are deploying a dual stage inflator module with stage 1 already deployed, the fixture may not move and the noise may
have been reduced.
13. Clear the area of people.
14. Separate the 2 banana plugs on the SIR deployment harness that were shorted together earlier in the procedure.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
RESTRAINTS
TO MODEL INDEX
S e c tion 08