Chevrolet Cruze 2012 Manual page 1463

BACK TO CHAPTER INDEX
Front Suspension
7. Remove the front wheel bearing/hub (1) and front brake shield (2) from the steering knuckle.
Installation Procedure
1. Position the front brake shield (2) and front wheel bearing/hub (1) assembly in the steering knuckle.
Caution: Refer to
2. Install the NEW front wheel bearing/hub bolts (1).
3. Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 kit .
• First pass to 90 N·m (67 lb ft)
• Second pass to 60°
• Third pass to 15°
4. Install the wheel drive shaft at the front wheel bearing/hub. Refer to
Wheel Drive Shaft Replacement - Right
Fastener Caution in the Preface section.
Side.
SUSPENSION
Front Wheel Drive Shaft Replacement - Left Side
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
or Front
TO MODEL INDEX