Chevrolet Cruze 2012 Manual page 1580

BACK TO MAIN INDEX
Special Tools
• CH 41013 Rotor Resurfacing Kit
• CH 42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to
Removal Procedure
Warning: Refer to
1. Check to ensure that the park brake is fully released.
2. Raise and support the vehicle. Refer to
3. Remove the rear tire and wheel assembly. Refer to
4. Remove the brake drum screw (1).
5. Remove the brake drum (2).
6. If the brake drum is to be reinstalled to the vehicle, use the CH 41013 resurfacer or equivalent to clean any rust or corrosion from
the hub/flange mating surface of the brake drum (2).
To clean any rust or corrosion from the hub/flange mating surface of the brake drum (2).
7. Use the CH 42450-A resurfacer or equivalent to clean the wheel hub flange.
Installation Procedure
1. If installing a new brake drum (2), use denatured alcohol or an equivalent approve brake cleaner and a clean shop towel to remove
the protective coating from the friction surface of the drum.
2. Adjust the drum brakes. Refer to
3. Install the drum brake.
Caution: Refer to
4. Install drum brake screw (1) and tighten to 7 N·m (62 lb in).
5. Install the tire and wheel assembly. Refer to
6. Lower the vehicle.
7. Apply the brakes approximately three times in order to seat and center the brake shoes within the drum.
Special Tools.
Brake Dust Warning in the Preface section.
Lifting and Jacking the
Drum Brake Adjustment.
Fastener Caution in the Preface section.
Tire and Wheel Removal and
ADDITIONAL LINKS
Vehicle.
Tire and Wheel Removal and Installation.
Installation.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 00
TO MODEL INDEX