Chevrolet Cruze 2012 Manual page 1483

BACK TO CHAPTER INDEX
Rear Suspension
Special Tools
EN 45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to
Removal Procedure
1. Raise and suitably support the vehicle. Refer to
2. Remove the tire and wheel assembly. Refer to
3. Without disconnecting the hydraulic brake flex hose, remove and support the rear brake caliper and bracket as an assembly, and
remove the rear brake rotor. Refer to
Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the
hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear
the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
4. Remove the wheel speed sensor bolt (1).
5. Remove the wheel speed sensor (2).
6. Remove and discard the wheel bearing/hub mounting bolts (1).
7. Remove the wheel bearing/hub assembly (1) and rear brake shield (2) from the rear axle.
SUSPENSION
Special Tools.
Lifting and Jacking the
Tire and Wheel Removal and
Rear Brake Rotor Replacement.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Vehicle.
Installation.
TO MODEL INDEX
S e c tion 10