Chevrolet Cruze 2012 Manual page 1423

BACK TO CHAPTER INDEX
Power Steering
Special Tools
EN 45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to
Removal Procedure
1. Turn the front wheels to the straight forward position and secure the steering wheel from moving.
2. Remove the lower steering intermediate shaft bolt (1).
3. Remove the steering intermediate shaft from the steering gear.
4. Raise and support the vehicle. Refer to
5. Remove the tire and wheel assemblies. Refer to
6. Remove the exhaust flexible pipe. Refer to
7. Remove the front compartment splash shield. Refer to
8. Remove the front compartment insulator, if equipped. Refer to
9. Remove the steering linkage inner tie rod. Refer to
10. Remove and discard the stabilizer link shaft nut (1) from the strut.
11. Remove the stabilizer link shaft from the strut.
12. Place a large container under the vehicle in order to collect the draining fluid.
13. Remove the power steering gear inlet and outlet hose bolt (1), remove the inlet and outlet hose (2) from the steering gear (3).
STEERING
Special Tools.
Lifting and Jacking the
Tire and Wheel Removal and
Exhaust Flexible Pipe
Front Compartment Splash Shield
Steering Linkage Inner Tie Rod
Vehicle.
Installation.
Replacement.
Replacement.
Front Compartment Insulator
Replacement.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 09
Replacement.
TO MODEL INDEX